banner



How To Install Brake Pedal Stop Pad

Fix The Brake Lights Stuck On (Or Broken Cruise Control) on a Honda or Acura

This commodity is visible to just you.

Prowl command no longer working in your Honda vehicle? Restriction lights stuck on? The set up may be surprisingly simple - all you demand is $5, a tiny part and a few minutes.

  • Restriction/Clutch pedal switch bumper stop pad - Yous tin buy a generic assortment from an automobile parts store or pick upward the OEM Honda one (Honda Part No. 46505-SA5-000). These should set you back about $5.

At that place are a few potential symptoms - Y'all may find your brake lights are stuck on (even with the primal removed and the ignition off). It's possible you might find your car dead if the stuck restriction lights went unnoticed and drained your bombardment.

Yous may also find your cruise control no longer functions (possibly without whatsoever alarm lights on your dash).

Find the broken stop pad

1

Unless you've cleaned your car recently look on the driver's side floor for a tiny broken pad, about the size of a penny. I included a picture of mine below.

Image 5959 from Fix the Brake Lights Stuck On (or Broken Cruise Control) on a Honda or Acura

ii

Hither you lot can come across the old pad and new pad side by side:

Image 5962 from Fix the Brake Lights Stuck On (or Broken Cruise Control) on a Honda or Acura

Determine where the new stop pad sits

3

Get downwardly low and look up at the pedals. You'll run into a gap where a switch almost comes in contact with a small round opening. This is where the stop pad is supposed to be.

My car is a transmission and it was the clutch stop pad that broke. You can run across the missing clutch stop pad forth with the present restriction stop pad.

If your pad(s) are still in place, make sure they're seated correctly. Y'all may take a cleaved switch instead.

Image 5965 from Fix the Brake Lights Stuck On (or Broken Cruise Control) on a Honda or Acura

Image 5968 from Fix the Brake Lights Stuck On (or Broken Cruise Control) on a Honda or Acura

Install the new stop pad

5

Press down on the brake or clutch pedal (probably with your hand depending on how much room you lot have) to motion the pedal abroad from the switch. If you're replacing the pad for the brake and you can't move it enough you may need to turn the auto on first. With the car on the brake pedal should depress farther.

6

Now push button the pad into the opening so release the pedal. If y'all're having difficulty plumbing equipment information technology in the opening the pressure on the pad should pop information technology into place once you release the pedal.

Image 5971 from Fix the Brake Lights Stuck On (or Broken Cruise Control) on a Honda or Acura

seven

The new pad should snap into place

Give information technology a examination

viii

Check your brake lights or requite the car a spin and engage the cruise control.

Image 5980 from Fix the Brake Lights Stuck On (or Broken Cruise Control) on a Honda or Acura

Honda Role No. 46505-SA5-000

Source: https://howtune.com/articles/278-fix-the-brake-lights-stuck-on-or-broken-cruise-control-on-a-honda-or-acura

Posted by: boydafterand.blogspot.com

0 Response to "How To Install Brake Pedal Stop Pad"

Post a Comment

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel